Important: Cloud will proceed upgrade on August 11 at 6AM (UTC +8) and it will take approximately 3 hours to complete. The services will continue to operate without any disruption during the upgrade period.
What’s New?
Enhancements & Fixes:
-
On-Demand Payment for Voucher Purchases
- Added support for on-demand payment using credit card when purchasing vouchers.
-
EAP112 – HALow Client Mode
- EAP112 now supports HALow client mode for long-range, low-power wireless connectivity.
-
Aprecomm On-Premise Setup Support
- Added capability to deploy Aprecomm in an on-premise environment.
-
EAP111 – Firmware v12.6.7 Support
- EAP111 is now compatible with firmware version 12.6.7.
-
NVR – New License Framework
- Introduced a new licensing framework for NVR management.
-
NVR – IP Camera Upgrade Support
- NVR now supports upgrading connected IP cameras directly.
-
Minimal Allowed Signal – Site Level
- Minimal allowed signal threshold configuration is now supported at the site level.
-
ECS4120 – LCAP Configuration Removal
- Fixed an issue where LCAP configuration was removed after adding the device to the cloud.
-
Configuration Failure – Loopback Detection
- Resolved configuration failures caused by loopback detection being enabled across all switch models.
-
Port VLAN Access Mode – Untagged Selection
- Fixed an issue where Access Mode VLAN ports were not automatically set as untagged, causing configuration errors.
-
SP W2 AC1200 – Band Steering Error
- Resolved an issue where changing operating mode to Client WDS triggered a band steering error.
-
VPC Cloud – Streaming Issue
- Fixed an issue where streaming did not work on VPC cloud instances.
-
Japanese Translation Adjustments
- Updated Japanese translations for Cloud, Site, Device, and Group menus for improved accuracy.
-
HALow Interface – Channel & Bandwidth Display
- Corrected an issue where the HALow interface displayed incorrect channel and bandwidth information when operating in Japan.